E46 double din install diy

Another part you may want to take into consideration is a "Steering Wheel Control" interface. In the trunk of the vehicle on the driver side, under the trunk liner you should find the stereo tuner. The antenna plug will be located on the top corner, you will want to disconnect it and use the EU to adapt it to a universal Motorola plug. On the bottom corner you will see the reverse harness, disconnect it and use the harness to integrate into the factory amp.

You will then want to extend the wires off the metra harness and run all the wires up behind the new stereo, including the 20ft antenna extension that you will want to connect to the Motorola Side of the antenna adapter.

You will want to use the high speaker level outputs off the back of the new Parrot stereo and connect them to the input wires you extended from the trunk. All speaker wires should be CEA color coded for easy identification.

The power wires you will need to find and connect separately using a digital multi meter. Unknown January 25, at AM. Unknown September 15, at PM.

Newer Post Older Post Home. Subscribe to: Post Comments Atom. Install the app. JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding. You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser. Thread starter hari95 Start date Apr 23, Tags alpine double din e46 e46 m3 e46 subwoofer m3. I have been looking for videos and threads to see how the subwoofers installed in terms of how to connect the aftermarket amp to the HK one if it needs to be done and which cables go where etc and what needs to come out guessing the cd changer, nav unit etc.

ExCopdT Flexing a golden cincture Jan 12, 4, Cheers, Dennis! ExCopdT said:. Click to expand ArtiM3 Wearing official robes Jun 20, You will need converter to change high signal from your stock amplifier to low. I used free air enclosure for slick look. I managed to fit mono block amp to the foam where mobility kit was.

I think for the time being id run the speakers from the stock amp within the car and run the sub using the RF amp.

Do you have to splice into the wires that go into the HK amp?